How to make and add Bear ears to any hood in 15 minutes - Rae Gun Ramblings
You can put bear ears on any pre-existing hood or if you are making the hooded vest start by sewing your hood pieces right sides together.
Make the ears by putting the 2 ear pieces right sides together then 1 interfacing piece on the back.
Sew around the curve leaving the straight edge.
Trim the seam allowance down to 1/8 inch.
Turn right side out and iron.
Make a small pleat in each ear and sew across the fold.
Put your hood on your head and mark where you want the ears to go.
Make slits where the ears should go. Slide the ears in and pin.
Sew across the slit making sure to close up the hole while sewing the ears.
Trim any excess that is hanging through the inside.