Measure Your Space. Figure out what size your design needs to be. Measure the maximum height and width that you have to work with.
Make Your Design. Go into Cricut Design Space and type the name you want to use and size it. More on this below.
Cut Out Your Vinyl. Place your vinyl shiny (right side) side up on your cutting mat and cut out your vinyl.
Weed Your Design. Remove any pieces that are not a part of your design. For example negative space, the holes in the letters A and O.
Transfer Your Design to Transfer Tape. Basically you are pulling the design off in one piece so that the sticky side is exposed. This allows you to place your design on the water bottle while maintaining the spacing and layout.
Place Your Design on the Water Bottle. Position and smooth out the vinyl sticky side down on the water bottle. Smooth and press it down through the transfer tape and carefully remove the transfer tape.
Allow to rest. Make sure you allow for time for the design to fully set before you use or wash the water bottle 24-48 should be fine.